JY CHEN - Ask Anything, Learn Everything. Logo

Questions in engineering

[Free] If smoke is present on a wheel end and it appears to increase, the technician should contact emergency services. A. True B. False

[Free] Which device is not considered an arcing device? A. Multimeter B. Circuit Breaker C. Fuses D. Relay Contacts

[Free] Which statement about impact wrenches is true? Impact wrenches: A. Are mainly used on soft joints. B. Typically run on hydraulic power. C. Have a high power-to-weight ratio. D. Maintain speed under various loads.

[Free] When would a reductant system tamper warning service bay test need to be performed after a service procedure on the system? A. To ensure that the service procedure was successful B. To test the efficiency of the DOC C. To clear the message on the instrument panel D. To recalibrate the ECM with the emission system

[Free] Why do closed hydronic systems include pressure-relief valves, expansion tanks, and temperature- and pressure-limiting devices? A. Because freezing must be prevented and antifreeze may not be added B. Because water expands and contracts as its temperature changes C. Because building codes require certain controls on every system D. Because the copper piping used in the system requires these measures

[Free] What is the significance of effective communication in steel erection? A. The team can discover shortcuts for the project B. The team can enhance the structural design C. The team can ensure worker safety D. The team can improve material quality

[Free] R-123 at 14.7 PSIA will boil at approximately: A. $90^{\circ} F$ B. $82^{\circ} F$ C. $78^{\circ} F$ D. $74^{\circ} F

[Free] Which of the following is a major advantage of battery-powered tools? A. Torque reaction B. Accuracy C. Power-to-weight ratio D. Portability

[Free] When designing the jumps of a BMX racetrack, the jumps involve a launch ramp and a landing ramp. What are some facts about the placement of these features? Check all that apply. A. There must be at least ten launch ramps in every course. B. The slope of a launch ramp cannot be too high or too low. C. The length of a landing ramp must be long enough for riders to recover from the jump, but short enough so they do not lose speed for the next jump. D. There can only be one landing ramp in every course. E. The slope of a ramp is found by dividing the height of the ramp by the length of the ramp.

[Free] Which of the following is a misuse hazard that could cause injury when using hand and power tools? A. Using a tool beyond its limits B. Using a tool that should be removed from service C. Using a tool with improper body positioning D. Using a tool when others are in harm's way E. All of the above